Vehicle shown in this step: 2007 Chrysler 300 2.7L V6
Procedure notes
This video shows you how to replace a burnt out rear turn signal on your 2010 Chrysler 300. We recommend that you change both the driver and passenger side bulbs at the same time on your 300 as they get dimmer over time and if one is out, then the other one is likely to burn out soon. If the turn signal (also known as a blinker or flasher) blinks rapidly or doesn't blink at all or lights up without blinking when it is turned on, this is your 300's way of telling you that the bulb is burnt out. Turn your hazard lights on and check the front of your 300 and then the back, whichever side is not lighting up is the side with the burnt out bulb.When changing the turn signal bulb in your 300, be careful not to touch the glass portion of the bulb with your fingers as this will cause the bulb to burn out prematurely.
查看中文对照 · Chinese translation
本视频演示如何更换您 2010 克莱斯勒 300 车辆的烧坏的后转向灯。 我们建议您在维修您的 300 时，同时更换驾驶员侧和乘客侧的灯泡，因为灯泡随时间会变暗，如果其中一个损坏，另一个也可能会很快烧坏。 如果转向灯（也称为闪烁灯或闪光灯）快速闪烁、完全不闪烁，或者在打开时灯亮但不闪烁，这是300在告诉你灯泡已烧坏。 打开危险警示灯，先检查 300 的前部，再检查后部；没有亮起的一侧就是灯泡烧坏的一侧。更换 300 的转向灯灯泡时，注意不要用手指触碰灯泡的玻璃部分，否则会导致灯泡过早损坏。