操作说明
本视频演示如何更换您的 2002 雪佛兰 Monte Carlo 车辆的前大灯灯泡，您的前大灯灯泡也可能被称为近光灯。 前大灯随时间推移亮度会逐渐变暗，最多可能降低 20%，最终会烧坏 - 因此，我们建议您成对更换前大灯。 同时更换您的 Monte Carlo 的两个前大灯灯泡，可以使两个灯泡亮度相同，避免新更换的灯泡比对侧的灯泡显得更亮。
在一些 雪佛兰 车型 车型中，远光灯和大灯共用同一个灯泡，可能出现远光灯正常工作而大灯烧坏的情况（反之亦然）。
一些 雪佛兰 车型 车辆配备了高强度放电头灯，有时也称为氙气灯。 氙气大灯具有一个镇流器，用于在开启时点燃高压氙气灯，即使灯关闭，镇流器仍可能保持通电状态。 更换前，请务必断开大灯总成或蓄电池。 如果您的 Monte Carlo 车型的 HID 头灯烧坏，可能是灯泡烧坏或头灯镇流器故障。
你的 Monte Carlo 车头灯灯泡更换费用因你选择哪家地方进行头灯更换而异。 雪佛兰 经销商的收费通常较高；AutoZone 等配件零售商往往会为在店内购买灯泡的顾客免费更换。 在更换 Monte Carlo 的大灯时，切勿用手指触摸灯泡的玻璃部分，因为指尖的油会使得灯泡该部分温度升高，从而显著缩短灯泡的使用寿命。
查看英文原文 · English original
This video shows you how to replace a headlight bulb in your 2002 Chevrolet Monte Carlo, your headlight bulb may also be known as a headlight low beam. Headlights grow dimmer by up to 20% over time and eventually burn out - for this reason, we recommend changing your headlights in pairs. Changing both headlight bulbs on your Monte Carlo at the same time will allow both bulbs to have the same intensity and prevent the new headlight bulb from appearing brighter than the bulb on the opposite side.
In some Chevrolets, the highbeam is the same bulb as the headlight and it is possible for the highbeam to work, but the headlight be burnt out even if they are the same bulb (and vice versa). Some Chevrolets have high intensity discharge headlights, sometimes referred to as xenon lights. Xenon headlights have a ballast to ignite the high voltage xenon lights when they turn on that can remain energized even if the lights are turned off. Be sure to disconnect the headlight assembly or battery before attempting to replace it. If your Monte Carlo has a HID headlight burnt out, it could be a burnt out bulb or failed headlight ballast.
The headlight bulb replacement cost for your Monte Carlo varies depending on where you go to get your headlight replaced. Chevrolet dealerships will tend to be pricier and parts retailers such as AutoZone will often replace it for free if you buy bulbs there. When you change the headlight on your Monte Carlo, it is important to not touch the glass part of the bulb with your fingers because the oil from your fingertips will cause that part of the bulb to burn hotter, which significantly shortens the life of the bulb.